MasterCam Posting With MasterCam

Home Forums Offline and Posting (CAM) MasterCam Posting With MasterCam

This topic contains 1 reply, has 2 voices, and was last updated by  Chris Pratt 3 years, 10 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
Author Posts
Author Posts
February 3, 2014 at 8:28 pm #1037

JMartin
Member

Is there any way to post a program for my ProtoTrak 1630sx using mastercam X6? I have tried everything and had no luck at all.

February 6, 2014 at 12:09 am #1060

Chris Pratt
Key Master

The software people at Mastercam should be able to provide you the required post (if you’re up to date with a license).  In a nutshell the post organizes the sequence of the g-code as well as removes commands the TRAK isn’t designed to understand.  You can even write you own if you are up against a wall.  The TRAK manual explains a bit more in the back section on posting.  Past customers have resorted to opening a generic post and making the edits required for the TRAK, then using their custom post.  hope this help, Chris

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.